Clary SP1250LX - Manual (Page 28)

28
4.5 UPS System Status
Once at this screen, press the ENTER/SHOW TIME button. Then press the SELECT/MENU MODE
button to go through the Battery System Status menu.
Shows the operating status of the UPS (NORMAL, BACKUP,……..etc).
Shows the Alarm status and number of alarms which are currently active (OVERTEMP, OVERLOAD,
OUTPUT BAD, INPUT IS BAD………...etc).
Shows the local and remote temperature in degrees Celsius. Remote temperature readings are available
only when an auxiliary temperature sensor is installed.
Shows the reason the UPS shutdown previously with an associated error code.
Press and hold both arrow buttons to initialize. This will set all settings except for the date and
time back to the factory default.
Press and hold both arrow buttons to initialize. This will set all settings to the default.
STATUS: UPS SYSTEM
St40: Operating Mode
NORMAL
St41: Alarm Status
1 ALARM
St42: Temperature
Loc 25C Rem 25C
NORMAL
St43: POWERDOWN Stat
f_code: 00 BATDEAD
NORMAL
St44: INITIALIZE ALL
PARAMS but TIME/DATE
NORMAL
St45: INITIALIZE ALL
LCD PANEL PARAMETERS
NORMAL