Aalborg PSV-D User Manual
Page 8
5
d.1 CE
Compliance
Any model PSV-D bearing a CE marking on it, is in compliance with the below
stated test standards currently accepted.
EMC Compliance with 89/336/EEC as amended;
Emission Standard: EN 55011:1991, Group 1, Class A
Immunity Standard: EN 55082 2:1995
(e)
OPERATING INSTRUCTIONS
e.1 Preparation
It is assumed that the PSV-D has been correctly installed as described in section
(b). Turn the DC power source ON. A pilot light on the front of the PSV-D will illu-
minate indicating the device is active.
e.2
Maximum Output Voltage to Valve
As shown in Figure e-1, remove the square plug of the PSV-D for the access win-
dow. Position 1, 2, and 3 on the header block determine the maximum output volt-
age supplied to the valve. The factory default setting is 22 VDC (position 2).
Table II Maximum Valve Output Selection
CAUTION: If the valve is left in the active mode for an extended
period of time, it may become warm or even hot to the touch. Use care
in avoiding direct contact with the valve during operation.
ƽ
Jumper Setting (position)
Output Voltage to Valve (VDC)
1
15
2
22
3
29