Flytec 5020 v1.18 * - Manual (Page 2)

Flytec 5020 technical manual
1 Operation
1.1 Turning the Unit On and Off
The unit is switched on by pressing the key. You must confirm the switch on, by
pressing the “Enter” key.
To switch it off, you need to press the same key for three seconds. The unit will then display
the question ‘switch off?? Press Enter’ Confirm by pressing “Enter”. After a long flight with
short record intervals the calculation of the digital signature can take up to one or two
minutes. Please wait until this process is finished. Press O/ESC key again to turn off the
unit.
1.2 Keypad
Main Setup Menu
===============
Factory Settings
Opt. SW-Packages
================↑
0%
25%
50%
Choose a
waypoint
Esc →Quit
©→Map display
on/off
Enter, accept
Choose a
route
75%
100%
Main Setup Menu
===============
Flightmemory
Waypoints
Routes
Restricted Areas
Simulation
Basic Settings
================↓
Set Marker
User Screen 1
Choose a user
selectable field
Nxt ↓ ----
Fnc ↓ Mod A1 ↑↓ QNH/Gps
↓ Mod A2 ↑↓ SET0
↓ S.Thr –0.8 SNK OFF/ON
↓ HT auto Man Wnd
User Screen 3
User Screen 2
Press short
Press long
- 2 -