iPazzPort KP-810-10A - Manual (Page 10)

ID CODE VERYFICATION:
Rarely but possible if two or more Wireless Handheld Keyboard are within a close
proximity the units may get confused. In that situation you need to run an ID Code Verification
procedure. This is very simple process. Please unplug all the Wireless Handheld Keyboard
and mouse touchpad and power off all of them, then select any pair of them and re-plug the
USB transceiver to the computor, press the ID RESET TRIGGER indicated by arrow23 till the
LED on the USB TRANSCIVER flash one time then release it, you will see the led on USB
receiver flash quickly, then press key “RF” indicated by arrow4 and Fn simutaneously, and
led2 on the keyboard will flash quickly, now release both of them and both two LEDS will go
out means the keyboard and USB receiver has finished its ID CODE VERYFICATION procedure.
After completed ID Code Verification, use mouserate.exe to confirm the Wireless Handheld
Keyboard works fine. Move TMP on Mouserate window, you read the average is
about 70 or above, as more as better. If it is below the value, please repeat to adjust.
After you have completed the ID Code Verification the Wireless Handheld Keyboard
will immediately enter power save mode. In order to wake the unit please presses any key.
There is another way for quick pairing the USB Receiver and iPazzPort, press key Fn and RF
simultaneously till LED3 falsh slowly, then release these two keys(you will see LED3 still
flash), now insert USB Receiver into USB port, you will see LED3 go out, that means USB
Receiver and iPazzPort pair successfully. What i want to emphasize is you must press these
two keys simultaneously.
Page 8 of 10