ACR Electronics 2662 - Manual (Page 48)

Select Submenu 7 “Inland AIS Configuration” with cursor button [Up] & [Down] by pressing
Nr. 7 on the keyboard.
This screen allows the user to toggle the quality of the speed, course or heading information received
from an external device. These settings are normally set to low.
Note: It is highly recommended to keep the settings to low.
Blue Sign:
Toggle the value from <not available> to <used> when a Blue Sign switch is connected. Setting the
blue sign can be done by an external hardware switch. Please see the chapter 3.12 how to connect
the blue sign - cable 2635 (NAU-B502) which includes and RS232 connector as well. Unless you
configure the Blue Sign appropriate, you may not be able to use it.
BlueSign Blue Sign <not available> no blue sign switch is connected
<used> when a blue sign switch is connected
N48^12' E 16^26' |1> N/A|2> N/A|3> N/Anm
|----------------------------------
| 5. Transponder Configuration
-----| |
| +- 1. Change User Password
View | +- 2. Region Settings
| +- 3. Alarm Settings
-----| +- 4. Interrogation Settings
| +- 5. Sensor Settings
Msg. | +- 6. GPS Settings
| +- 7. Inland AIS Configuration
-----|
|
Displ|
----------------------------------------
NUM|Select->| | |<-Back
N48°12' E 16°26' |1> N/A|2> N/A|3> N/Anm
******* Inland AIS Configuration *******
Quality information
Speed : Low
Course : Low
Heading: Low
BlueSign :<used>
----------------------------------------
| Save | | | Exit
44 Y1-03-0212H