3 enclosure mounting kit – Campbell Scientific CC640 Digital Camera User Manual
Page 45
Advertising
CC640 Digital Camera
15.3 Enclosure Mounting Kit
The 18549 Enclosure Mounting Kit is used to mount the 18543 camera
enclosure to a CM202, CM204, or CM206 crossarm. The crossarm then
attaches to a tripod, tower, or user-supplied pole (1.0” to 2.1” outer diameter).
Figure 20 shows the camera enclosure mounted to a crossarm via this bracket.
The enclosure fastens to the bracket via two #5226 screws (1/4-20 x .5 cap hex
grade 5) and two #5428 washers (1/4 flat SS). A u-bolt connects the bracket to
a crossarm. Curved notches in the bracket allow you to aim the camera at the
desired target.
Camera
Enclosure
Bottom
Crossarm
Cable Port
Cable Port
Curved Notch
U-bolt
Curved Notch
#5226 Screw
#5226 Screw
FIGURE 20. Camera Mount to Crossarm
39
Advertising