Campbell Scientific TX320 Transmitter - Manual (Page 14)

TX320 Transmitter
FIGURE 4-2. Settings Editor | Configuration in Device Configuration
Utility
If NESDIS has not assigned a Random Channel, the following
parameters do not apply. NOTE
Random Transmission Channel: Select the NESDIS-assigned random
transmission channel. Setting the channel number to a value of zero will
disabled random transmissions.
Random Transmission Bit Rate: Select the NESDIS-assigned channel bit
rate (baud rate). This value will be either 300 or 1200 for a CS-2 device.
Random Transmission Window Length(s): Specify the randomizing interval
in units of minutes. This value is the interval at which a random transmission
will take place if there is data in the random buffer. The actual interval will be
random but will, on average, occur at this rate.
4