Samsung RSG5PURS - Manual (Page 13)

setting up _13
01 SETTING
UP
Be careful not to miss the parts of refrigerator.
3. Next, remove the door from the lower hinge 6 by
carefully lifting the door straight up 7 .
Be careful not to pinch the water tubing and
wire harness on the door.
4. Remove the lower hinge 8 from the bracket 9
by gently lifting the lower hinge upwards.
2. Insert the 2 clips in the install pack and check that
each clip holds the line fi rmly.
Do not cut the water line. Gently separate it
from the coupler.
Removing the freezer door
A few things to mention fi rst.
• Make sure that you lift the door straight up so the
hinges are not bent or broken.
• Be careful not to pinch the water tubing and wire
harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
1. With the Freezer door closed, remove the upper
hinge cover 1 using a screwdriver, and then
disconnect the wires by gently pulling them apart
2 .
2. Remove hinge screws 3 and the ground screw
4 by turning counter-clockwise, and take off the
upper hinge 5 . Be careful that the door does not
fall on you as you are removing it.
1
2
- on some models - on some models
5
4
3
6
7
9
8
clip A (1/4”) clip A (1/4”)
(6.35mm)
(6.35mm)