Installing the water dispenser line, Checking the water dispenser line, Connecting the water line to the refrigerator – Samsung RSG5PURS User Manual

Page 16: Caution

Advertising
background image

16_

setting up

4. After connecting the water supply to the water

fi lter, turn your main water supply back on and
Dispense about 3L to clear and prime the water
fi lter.

INSTALLING THE WATER
DISPENSER LINE

Connecting the water line to the
refrigerator

1. Remove the cap from water line on the unit and

insert compression nut to the water line on the
unit after disassembling from provided water line.

2. Connect both water line from the unit and water

line in the kit

3. Tighten the compression nut onto the

compression fi tting. Be careful no gap between
two items.

4. Turn water on and check for any leakage.

CHECKING THE WATER
DISPENSER LINE

A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system to do
that.

In order for the icemaker to operate properly, water
pressure of 138 ~862 kPa is required. Under normal
conditions, a 170 cc paper cup can be fi lled in 10
seconds.

If the refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure.

Make sure the water storage tank inside the
refrigerator is properly fi lled. To do this, press the
water dispenser lever until the water runs from the
water outlet.

Water Line installation Kits are included with
unit. You can fi nd it in freezer(or fridge) drawer.

The new hose-sets supplied with the
appliance are to be used and that old hose-
sets should not be reused.

Parts for water line Installation

Connecting to the water supply line

1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water Line Installation Instructions in

the installation kit.

1 Water line fi xer

Water line fi xer
and screws

and screws

2 Pipe connector

Pipe connector

3 Water line

Water line

4 Clip

Clip

5 Water Filter

Water Filter

CAUTION

The water line must be connected to
the cold water pipe.
If it is connected to the hot water pipe,
it may cause the purifi er to malfunction.

Close Main

Close Main
Water pipe

Water pipe

Close Main

Close Main
Water pipe

Water pipe

No gap

No gap

Remove

Remove

cap

cap

Water Line

Water Line
from unit

from unit

Water Line

Water Line
from Kit

from Kit

No gap

No gap

Loosen a

Loosen a

Advertising
This manual is related to the following products: