ADIC FastStor - Manual (Page 10)

Advanced Digital Information Corporation FastStor 1
6 FastStor 1 Quick Installation Guide
Figure 5 shows step 5 in the description:
Rack mounting kit mounted in rack with
one screw M6x12 in upper hole on both
left and right sides.
On the rear side, two screws must be
used on both left and right sides.
A total of six screws are used to install
the rack mounting kit to the rack.
Figure 5. Rack mounting kit
mounted in rack
Mounting the FastStor 1 to the Rack
Make sure all screws in the Rack Mounting Kit are tightened properly before installing the
FastStor 1 in the rack.
Slide the FastStor 1 on the rails from the front of the rack, as shown in Figure 6. Then
secure the FastStor 1 using one M6x12 screw in front of the rack on both left and right sides
(see Figure 7), and one M5x8 on the back of the Rack Mounting Kit on both left and right
sides (see Figure 8).
Figure 6. Slide the FastStor 1 in
from the front.
Figure 7. Fasten the front of the
FastStor 1 to the rack.