ADIC FastStor - Manual (Page 9)

FastStor 1 Quick Installation Guide 5
Installing the “Rail Left Assembly”
1. Measure the length between the rear rack mount rails and the front rack
mount rails. If the measurement is shorter than the FastStor 1, move the two
sets of screws M4x12, washers and nuts shown in Figure 4.
2. Adjust the “Rail Left Assembly” to fit the measurement in step 1.
3. Use a 7 mm open-end wrench together with the screwdriver to tighten the
two M4x12 screws to fix the rail length.
Note: Using more than two screws
will increase the stability of the Rack Mounting Kit.
4. Place the “Rail Left Assembly” on the left side of the rack, between the rear
rack mount rail and the front rack mount rail.
5. Mount the “Rail Left Assembly” at the desired height using one M6x12 screw
in front (upper hole in rail only) and two M6x12 screws at the back. See
Figure 5.
Installing the “Rail Right Assembly”
Follow the instruction for left side only using the “Rail Right Assembly” on the right
side of the rack.
Figure 4. Mounting the Rack mounting kit to a rack
Step 5
(Screw
M6x12)
Step 1
Rear Rack
Mount Rail
Use these holes
if rack depth is
equal to or
longer than the
FastStor 1
Step 1
Use these holes
if rack depth is
shorter than the
FastStor 1
Front Rack Mount Rail
Step 5
(Screw M6x12)
Step 2
Step 3
(Screw M4x12,
nut and washer)