AT&T TL7612 - Manual (Page 15)


Headset base and handset lifter installation
No lifter mode or lifter mode
There are two answer modes available on the headset base. The
current mode is indicated
by the
NO LIFTER MODE or LIFTER MODE lights
on the front of the headset base.
When plugging your headset base into the
telephone wall jack, make sure the headset
base mode is set to
NO LIFTER MODE.
-OR-
When connecting your headset base to a corded telephone,
make sure the headset base mode is set to
LIFTER MODE
and that the LIFTER AUDIO ADJUST is switched for the best
headset audio quality.
To change the answer mode:
When the headset is not in use, press
MODE on the headset
base to select NO LIFTER MODE or LIFTER MODE. The
corresponding light on the front of the headset base turns on to
indicate the current mode.
NOTE: If you are using the handset lifter, you must use the LIFTER MODE.
•
•
MODE