Atlantis Land I-See S 150 - Manual (Page 9)

A05-15AM-C01_MX02 9 / 45 _1
d. power on
Turn on both of the monitor and computer. After the monitor is power on, the LED
lights up green, If the LED become red and flashing, please check the video signal
cable fig.2 connection If LED is off, please press power on switch .
2.1.4.1 Self test pattern
If there is no horizontal or vertical sync. signals,
your monitor will display as fig.2 to indicate no
signal input. After a few seconds, the monitor
will enter into waiting and saving power mode.
the LED will be red and flashing.
Once the monitor receives the video signal, it
will return to normal mode.
2.1.5 Adjust picture
In order to obtain the best visual display, you must
adjust it, please refer to chapter 3“operation of the
monitor”.
• Hanging
style
The customer may hang the monitor on the wall when
necessary. operations as following
• take down the base and the signal cable clip,
you will see two bolts in the knighthead.
screw down the two bolts and take apart the
plastic covers and screw down the bolts that
connect the knighthead and axis of the
rotation.
• clear up the signal cable, power cord and
audio cable
• hook the monitor on the wall by the four holes of the back of monitor
2.2 Operations
2.2.1 Power on/off switch
This is a slight-touch digital-control key. It is
used to turn the monitor on or off.
2.2.2 Power LED indicator
When the monitor is working, the power LED
is green. If the monitor is in saving power
mode, the power LED will be red and
flashing. If you turn off the computer, the
power led is off. When the LED is off, the
monitor is off, but
the power adapter is on. For the purpose of
security,
you should turn off adapter power when you
don’t use the monitor.
ATLANTIS LAND