American Audio Q-MX2 BPM User Manual
Page 7
22. AC VOLTAGE SELECTOR - Select between 115V/50Hz or 230V/60Hz. Make sure that the selector is
set to the proper voltage you are using.
23. BALANCED XLR MAIN OUTPUTS - The Master Output includes a pair XLR Balanced Jacks as well as
a pair RCA Unbalanced Jacks (30). The 3-pin XLR jacks send a high current balanced output signal.
These jacks should be used when you will be driving an amp or other audio equipment with a balanced
input, or whenever you will be running a signal line greater than 10 feet.
24. LIGHT CONTROL - This jack provides a preset mono audio signal output. There is no way to adjust this
level, however this level will directly reflect the output level of the Channel Sliders (4). This buffered
audio output should only be used for light controllers that can accept an external audio input. Great for
Touch Panels and Chase Controllers.
25. PLAYER CONTROL - Channel 1, 2, and 3 external FADER “Q” START CONTROL. These jacks are used
to input 1/8" mono mini plugs from a compatible American DJ "Q" series CD players also featuring Fader
“Q” Start. This feature is used to remote control a CD player. By moving the mixer fader from left to right
you can start and pause a compact disc player. In other words, when the mixer crossfader is to the left (X
position), and you move it at least 20% to the right (Y position), any player connected to the Y-channel will
begin to play. When the crossfader is to the right (Y position), and you move it at least 20% to the left (X
position, any player connected to the X-channel will begin to play. You can create great effects similar
to scratching with this feature.
26. MIC 2 INPUT JACK - This jack is used to a connect a microphone to the mixer. Connect you mic to MIC
2 via 1/4 inch (6.3mm) jack. The signals will be controlled by Channel 2 (4). BASS, MID, and TREBLE can
be adjusted by the Channel EQ (13).
27. MIC 1 INPUT JACK - This jack is used to a connect a microphone to the mixer. Connect you mic to MIC
1 via 1/4 inch (6.3mm) jack. The signals will be controlled by Channel 1 (4). BASS, MID, and TREBLE can
be adjusted by the Channel EQ (13).
28. GND (GROUND TERMINAL) - Connect each of your turntable ground leads to this terminal. This will
reduce the humming and popping noises associated with magnetic phono cartridges.
©
American DJ Supply
®
- www.americandj.com - Q-MX2 BPM User Instructions page 7
31
26
36
39
34
38
27
32
24
25
40
28
29
33
35
37
41
30
REAR PANEL - CONTROLS AND FUNCTIONS CONT.