Uso de la batería, How to use the battery pack, Instalación y extracción de la batería – Samsung HMX-S10BN-XAC User Manual

Page 20: Battery pack installation / ejection

Advertising
background image

ENGLISH

ESPAÑOL

20

20

Uso de la batería

Instalación y extracción de la batería

Se recomienda adquirir una o más baterías para poder utilizar la
Miniket Photo de forma continua.

Para introducir la batería

1. Empuje el interruptor [OPEN] en la

parte inferior del aparato en la
dirección de ! como se muestra
en la figura y abra la tapa @.

2. Introduzca la batería en la ranura

hasta que emita un chasquido
suave.
Asegúrese de que el logotipo de
SAMSUNG esté hacia arriba con el
aparato colocado como se muestra
en la figura.

Para expulsar la batería

1. Empuje el [interruptor de bloqueo

de la batería] en la dirección que se
muestra en la figura para expulsar
la batería.

2. Saque la batería en la dirección que

se muestra en la figura.

[ Notas ]

✤ Limpie los terminales para eliminar sustancias extrañas antes de

insertar la batería.

✤ Si no va a utilizar la Miniket Photo durante un tiempo, retire la

batería de la Miniket Photo.

✤ Se recomienda preparar baterías adicionales totalmente cargadas

para su uso en el exterior.

✤ Las baterías adicionales se encuentran disponibles en el

distribuidor local y en el Servicio técnico de Samsung.

[ Advertencia ]

✤ Cuando expulse la batería de la Miniket Photo, sujete la batería

para impedir que caiga al suelo.

How to Use the Battery Pack

Battery Pack Installation / Ejection

It is recommended to purchase one or more additional Battery Packs
to allow continuous use of your Miniket Photo.

To insert the Battery Pack

1. Push the [OPEN] switch on the

bottom side of the set in the direction
of ! as shown in the diagram and
open the lid.@

2. Insert the Battery Pack into the

battery slot until it softly clicks.
Make sure that the SAMSUNG logo
is facing up while the set is placed as
shown in the diagram.

To eject the Battery Pack

1. Push the [Battery Lock Switch] in the

direction as shown in the diagram to
pop the Battery Pack out.

2. Pull the ejected Battery Pack out in

the direction as shown in the diagram.

[ Notes ]
✤ Clean the terminals to remove any foreign substances before

inserting the Battery Pack.

✤ If the Miniket Photo will not be in use for a while, remove the

Battery Pack from the Miniket Photo.

✤ It is recommended to prepare fully charged additional Battery

Packs for outdoor use.

✤ Additional Battery Packs are available at your local Samsung

dealer and service center.

[ Warning ]
✤ When you eject the Battery Pack from the Miniket Photo, hold the

Battery Pack so as not to drop it.

<Inserting the Battery Pack>

<Ejecting the Battery Pack>

MENU

O

P

E

N

@

!

MENU

MENU

Cover

Battery Lock

Switch

00934E SC-MS10 USA+ESP~037 11/25/05 2:40 PM Page 20

Advertising
This manual is related to the following products: