Samsung HPS4253X-XAP - Manual (Page 37)

37
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna) and cable
channels. After the available channels are memorized, use the CH
and CH buttons to scan
through the channels. This eliminates the need to change channels by entering the channel digits.
There are three steps for memorizing channels: selecting a broadcast source, memorizing the
channels (automatic) and adding and deleting channels (manual).
Selecting a broadcast source
Before your television can begin memorizing the available channels, you must specify the type of signal
source that is connected to the TV (i.e., an antenna or a cable system).
1 Press the MENU button. Press the ▲ or ▼ button to select
“Channel”, then press the ENTER button.
2 Press the ▲ or ▼ button to select “Auto Program”, then
press the ENTER button.
3 Press the ▲ or ▼ button to select the antenna connection,
then press the ENTER button.
Notes
• Air : “Air” antenna signal.
• Cable : “Cable” antenna signal.
• Air + Cable : “Air” and “Cable” antenna signals.
• If the antenna is connected to ANT 1 IN (CABLE),
select “Cable” and if it is connected to
ANT 2 IN (AIR), select “Air”.
• If both ANT 1 IN and ANT 2 IN are connected,
select the “Air + Cable”.
Antenna : Air √
Auto Program √
Channel Manager √
Name √
Fine Tune √
Signal Strength √
† More
Channel T V
Move Enter Return
Antenna : Air √
Auto Program √
Channel Manager √
Name √
Fine Tune √
Signal Strength √
† More
Channel T V
Move Enter Return
Auto Program T V
Move Enter Return
Select the antennas to memorize.
Air
Cable
Air + Cable Start
Start
Start
Auto Program T V
Move Enter Return
Select the antennas to memorize.
Air
Cable
Air + Cable Start
Start
Start
➤ ➤
Quick way to select Auto Program: Just press “AUTO PROG.” button on the
remote control.
BN68-00991B-01Eng(032~051) 2/17/06 1:57 PM Page 37