Asus Motherboard P4GE-VM - Manual (Page 26)

1-16 Chapter 1: Product introduction
®
P4GE-VM
P4GE-VM Bass/Center Setting
BCS1
BCS2
1 2 2 3
(BASS/CENTER) (CENTER/BASS)
(Default)
6. Bass/Center setting (3-pin BCS1, BCS2) (on audio models only)
These jumpers allow you to select the speaker output for a 6-channel audio
system. Switch the jumpers from the BASS/CENTER (pins 1-2) position to
CENTER/BASS (pins 2-3) position to re-route signals on the internal leads of
the Mic port.
1. Install the audio driver from the support CD to activate the 6-channel audio
feature.
2. If your motherboard does not have the BCS1 and BCS2 jumpers, adjust the
speaker output settings using the 6-channel audio software interface.
1.11 Connectors
This section describes and illustrates the internal connectors on the motherboard.
1. Hard disk activity LED (2-pin IDE_LED)
This connector supplies power to the hard disk activity LED. The read or write
activities of any device connected to the primary or secondary IDE connector
cause this LED to light up.
®
P4GE-VM
P4GE-VM HDD Activity LED
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.
IDE_LED