Asus Motherboard P4GE-VM - Manual (Page 29)

ASUS P4GE-VM motherboard user guide 1-19
®
P4GE-VM
P4GE-VM Chassis Alarm Lead
CHASSIS
+5VSB_MB Chassis Signal GND
(Default)
7. Chassis intrusion connector (4-1 pin CHASSIS)
This lead is for a chassis designed with intrusion detection feature.
This requires an external detection mechanism such as a chassis
intrusion sensor or microswitch. When you remove any chassis
component, the sensor triggers and sends a high-level signal to this
lead to record a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. If you wish to use the chassis intrusion detection
feature, remove the jumper cap from the pins.
®
P4GE-VM
P4GE-VM 12-Volt Cooling Fan Power
CPU_FAN1
CHA_FAN1
GND
Rotation
+12V
GND
Rotation
+12V
6. CPU and Chassis Fan Connectors (3-pin CPU_FAN1, CHA_FAN1)
The fan connectors support cooling fans of 350mA~740mA (8.88W max.) or a
total of 1A~2.22A (26.64W max.) at +12V. Connect the fan cables to the fan
connectors on the motherboard, making sure that the black wire of each cable
matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Lack of sufficient
air flow within the system may damage the motherboard components. These
are not jumpers! DO NOT place jumper caps on the fan connectors!