Samsung HW-HM45-ZA - Manual (Page 22)

FUNCTIONS
22
SOFTWARE UPDATE
Samsung may offer updates for the Soundbar's
system firmware in the future.
If an update is offered, you can update the firmware
by connecting a USB device with the firmware
update stored on it to the USB port on your
Soundbar.
Note that if there are multiple update files, you must
load them onto the USB device singly and use them
to update the firmware one file at a time.
Please visit samsung.com or contact the Samsung
call center to receive more information about
downloading updates files.
● Insert a USB device containing the
firmware update into the USB port on the
main unit.
● Updating firmware may not work properly
if audio files supported by the Soundbar
are stored in the USB storage device.
● Do not disconnect the power or remove
the USB device while updates are being
applied. The main unit will turn off
automatically after completing the
firmware update.
● After reset, all settings are reset to their
factory default settings. We recommend
you write down your settings so that you
can easily reset them after the update.
Note that updating firmware resets
subwoofer connection too. If connection
to the subwoofer is not established
automatically after resetting,
refer to page 13.
If the firmware fails to update, we
recommend formatting the USB device in
FAT16 and trying again.
● Once the software update is completed,
turn off the product and then press and
hold the ( & ) button on the remote
control for more than 5 seconds. “INIT”
appears on the display and the unit is
powered off. The updgrade is complete.
● Do not format the USB device in the NTFS
format. The Soundbar does not support
the NTFS file system.
● Depending on the manufacturer, some
USB devices may not be supported.