Samsung DV455GVGSWR-AA - Manual (Page 28)

English - 28
Operating instructions, tips
Quick Dry - Provides a 30 minutes drying cycle.
Air Fluff - The Air Fluff cycle tumbles the load in room temperature air.
Refresh - This cycle is best for smoothing out wrinkles and reducing odors
from loads consisting of one to four dry items. In this cycle a small amount
of water is sprayed into the dryer drum after several minutes of tumbling with
heat.
Wrinkle Away - The Wrinkle Away cycle removes wrinkles from clothes stored
in closets, etc. It provides wrinkle release via optimized steam care. You can
change the drying time.(Minimum time : 20 minutes) *For best results, load no
more than 3 items.
Overloading the dryer may not yield the same results.
2 LED Display
The display window shows the estimated time remaining in the cycle after the
Start/Pause button is pressed. The estimated time remaining may fl uctuate as
the cycle progresses.
The Drying light will illuminate and remain lit until the cycle is complete.
When your dryer is in the cool-down phase, the Cooling light will illuminate.
When your dryer is in the wrinkle prevent phase, the Wrinkle Prevent light will
illuminate.
When the cycle is complete, “End” will appear in the display panel until the
dryer door is opened or the Power button is pushed.
If your dryer is paused during a cycle, the indicator lights will blink until the
Start/ Pause button is pressed.
3
Dry Level
Selection Button
To select the dry level in the Normal, Heavy Duty, or other Sensor Dry cycles,
press the Dry Level button. An indicator light will illuminate next to the desired
dryness level.
Press the button repeatedly to scroll through the settings. Larger or bulkier
loads may require the Very Dry or More Dry setting for complete dryness.
The Less Dry setting is best suited for lightweight fabrics or for leaving some
moisture in the clothing at the end of the cycle. Damp Dry is designed to
partially dry items. Use for items that lay fl at or hang to dry.
4
Temp Selection
Button
To select the correct temperature for the load, press the Temp button. An
indicator light will illuminate next to the desired temperature. Press the button
repeatedly to scroll through the settings.
High – For sturdy cottons or those labeled Tumble Dry.
Medium – For permanent press, synthetics, lightweight cottons, or items
labeled Tumble Dry Medium.
Med Low – For lower heat than Medium to dry synthetic or washable knit
fabrics.
Low – For heat sensitive items labeled Tumble Dry Low or Tumble Dry Warm.
Extra Low – Provides the lowest heated dry temperature possible.
5
Time Selection
Button
When using Manual Dry cycles, you can adjust the drying time by pressing the
Time selection button.
During the Sensor Dry cycle, the time light indicator is off because exact
drying times are determined by fl uctuating humidity levels.
DV455_02836F-08_EN.indd Sec3:28 DV455_02836F-08_EN.indd Sec3:28 2013-12-12 5:11:57 2013-12-12 5:11:57