Samsung DV455GVGSWR-AA - Manual (Page 36)

English - 36
Operating instructions, tips
Connecting to the network using the WPS setting
Your Samsung dryer uses Wi-Fi Protected Setup/Push Button Confi guration WPS(PBC) as
the primary method of connecting to a wireless router or modem. If your router or modem
is WPS compliant and has a WPS button, you can easily connect your dryer to your router/
modem.
1. Press and hold both the Temp. and Start/Pause buttons
for 3 seconds.
2. Turn the Cycle Selector until “UP” is displayed on the
display panel, and then press the Start/Pause button.
If the connection is not established within 5 minutes,
“FUP” is displayed on the display panel.
3. Press and hold the WPS button on the wireless router/
modem within 120 seconds to run the WPS function.
If the WPS function runs, the wireless router/modem
automatically fetches the necessary information from the
dryer and the dryer is automatically connected to the
Internet through the wired/wireless router/modem.
• The way the WPS function runs on your wireless router/modem may diff er
depending on the manufacturer. Refer to the user manual of your router/modem for
details.
• Even after the WPS setup is complete, it may take some time until the actual
connection is established and an IP address is allocated through through DHCP (up
to 5 minutes).
• Note that if you use a wireless router/modem that is not WPS-certifi ed, the dryer
may not be connected through Wi-Fi or another device that was connected to the
wireless router/modem may be disconnected.
• Please note that for some wireless router/modem, if you press and hold the WPS
button for some time, the settings of the router/modem may be reset.
4. If the dryer and the wireless router/modem are properly
connected, the indicator blinks on the display panel for
30 seconds.
5. Press and hold the Signal On/Off button for 3 seconds
to fi nish the Smart Control connection setup. When the
setup is completed normally, the
indicator blinks on the
display panel accompanied by a beeping sound.
If you press and hold the Signal On/Off button for 3
seconds when the dryer and the wired/wireless sharer
are not properly connected, the invalid button sound
is heard and the Smart Control connection setup is
not completed.
CAUTION
DV455_02836F-08_EN.indd Sec3:36 DV455_02836F-08_EN.indd Sec3:36 2013-12-12 5:11:59 2013-12-12 5:11:59