Samsung RS25H5000SR-AA - Manual (Page 16)

English - 16
CHECKING THE WATER
DISPENSER LINE
A water dispenser is one of the helpful features on
your new Samsung Refrigerator.
To help promote better health, the Samsung water
filter removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
In order for the ice maker to operate properly, a
water pressure of 20~125 psi (pound per square
inch) is required.
Under normal conditions, a 170 cc (5.75 oz.) paper
cup can be filled in 10 seconds.
If the Refrigerator is installed in an area with low
water pressure (below 20psi), you can install a
booster pump to compensate for the low pressure.
Make sure the water storage tank inside the
Refrigerator is properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water supply kit
that contains copper tubing.
Connecting to the water supply line
1. First, shut off the main water supply line and
turn the ice-maker off.
2. Locate the nearest cold, drinking water line.
3. After connecting the water supply to the water
filter, turn your main water supply back on and
flush 3 gallons (Flush approximately 6 minutes)
into a bucket to clear and prime the water filter.
Shut off valve
Pipe clamp
Cold water line
Water line installation kit
INSTALLING THE WATER LINE
Connecting the water line to the
Refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
• 1/4” compression nut • plastic tubing
• copper tubing • ferrule
Compression Nut
(1/4”) (Assembled)
Ferrule
(Not supplied)
Plastic Tubing
(Supplied)
Compression Fitting
(Assembled)
Bulb (B)
Compression
nut (B) (1/4”)
(Not supplied)
or
Copper tubing
(Not supplied)
Plastic tubing (B)
(Not supplied)
Household water line
Refrigerator
1. Tighten the compression nut ( B ) into the 1/4”
compression fitting.
- If you are using copper tubing, slip the
compression nut ( B ) (not included) and ferrule
(not included) on copper tubing (not included)
as shown.
- If you are using plastic tubing ( B ), insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
CAUTION
Do not use without the molded end (Bulb) of the
plastic tubing (
B ).
SSEDA-14 (RS25H5121) ���.indd 16 2013. 11. 28. �� 11:28