Installation (sw-hdm3d-c5-4x4), Receiver – Avenview SW-HDM3D-C5-4X4 User Manual
Page 12
www.avenview.com
12
1.8 Installation (SW-HDM3D-C5-4X4)
To setup Avenview SW-HDM3D-C5-4X4 follow these steps for connecting to a device:
1.
Connect all sources to HDMI Inputs on the 4X4 HDMI over CAT5 Matrix Switch (SW-HDM3D-C5-4X4)
2.
Connect each DDC output on the SW-HDM3D-C5-4X4 to respective DDC input on the remote receiver
HDM3D-C5SW-R
3.
Connect each TMDS output on the SW-HDM3D-C5-4X4 to respective TMDS input on the remote
receiver HDM3D-C5SW-R
4.
Connect IR emitter cable to the SW-HDM3D-C5-4X4 and direct the IR emitter to the build-in IR
receiver of the sources
5.
Connect the +5V 6A DC power supply to the SW-HDM3D-C5-4X4
6.
Power on all HDMI sources
7.
Power on the SW-HDM3D-C5-4X4
Receiver
1.
Connect each HDMI output to HDMI displays.
2.
Connect the HDMI SIGNAL port with CAT6 on the HDM3D-C5SW-R to the HDMI SIGNAL port on the
SW-HDM3D-C5-4x4.
3.
Connect the IR CONTROL port on the HDM3D-C5SW-R to the IR CONTROL port on the
SW-HDM3D-C5-4x4.
4.
Connect IR receiver and place the IR receiver at the appropriate position that can receive the IR
command signals sent from the users.
5.
Dial the 8-level rotary control switch to adjust the HDMI signal level until the picture and sound are
clear. It is recommended to dial from 7 to 0 to find the optimal visual experience