Samsung HPN4239X-XAC - Manual (Page 17)

Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal
source that is connected to the PDP (i.e., an antenna or a cable system).
1 Press the MENU button. Press the ▲ or ▼ button to
select “Channel”, then press the ENTER button.
2 Press the ENTER button to select “Air/CATV”.
3 Press the ▲ or ▼ button to select “Air”, “STD”,
“HRC” or “IRC”.
• If you are connected to an antenna, leave “Air”
displayed. If you connected cable, press the
▲
or ▼ button to the display the type of cable
system: “STD”, “HRC” or “IRC”.
(If you are not sure which type of cable system you
have, contact your cable company).
4 Press the MENU button to exit.
Note
• STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to
identify the type of cable system that exists in your particular area. At this point the signal source
has been selected. Proceed to “Storing Channels in Memory” (Next page).
Memorizing the Channels
Your PDP can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH
and CH
buttons to scan through the channels. This eliminates the need to change channels by entering
the channel digits. There are three steps for memorizing channels: selecting a broadcast
source, memorizing the channels (automatic) and adding and deleting channels (manual).
32 33
Storing Channels in Memory (Automatic Method)
1 First, select the correct signal source (Air, STD, HRC
and IRC). See steps on previous page.
Press the MENU button. Press the ▲ or ▼ button to
select “Channel”, then press the ENTER button.
2 Press the ▲ or ▼ button to select “Auto Program”,
then press the ENTER button.
3 The PDP will begin memorizing all of the available
channels.
After all the available channels are stored, the Auto
program menu reappears. Press the MENU button to
stop.
Note
• The PDP automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
➤ ➤ Quick way to access the Automatic Channel Setting: Just press the
“AUTO PROG.” button on the remote control.
Air / CATV : Air √
Auto Program √
Add / Delete √
Fine Tune √
LNA : On √
Ch.Scan √
Channel
Auto Program
Air 28
Move Enter Return
Air / CATV : Air √
Auto Program √
Add / Delete √
Fine Tune √
LNA : On √
Ch.Scan √
Channel
Move Enter Return
Return
Air / CATV : Air √
Auto Program √
Add / Delete √
Fine Tune √
LNA : On √
Ch.Scan √
Channel
Move Enter Return
Air / CATV :
Auto Program
Add / Delete
Fine Tune
LNA
: On
Ch.Scan
Channel
Move Enter Return
Air
STD
HRC
IRC
Air / CATV :
Auto Program
Add / Delete
Fine Tune
LNA
: On
Ch.Scan
Channel
Move Enter Return
Air
STD
HRC
IRC