Samsung HPN4239X-XAC - Manual (Page 7)

¸ SURROUND button
Press the hear the Dolby surround effect.
˛ MTS button
Press to choose stereo, mono or Separate Audio Pro-
gram (SAP broadcast).
◊ AUTO PROG. button
The TV automatically cycles through all of the avail-
able channels and stores them in memory.
± ADD/DEL button
Press to add or delete channels in the TV’s memory.
≠ DNIe button
Activates DNIe (Digital Natural Image engine).
– CAPTION button
Controls the caption decoder.
— SET button
Used during set up of this Samsung remote control,
so that it will work compatibly with other devices
(VCR, cable box, DVD)
÷ PIP control buttons
SWAP : Exchanges the video signal that is
currently displayed on the main screen
with the signal in the PIP window.
SIZE : Press to make the PIP window Large,
Small or Double.
CH , : Displays the available channels in
sequence. (These buttons change channels
in the PIP window only).
® VCR, DVD control buttons
Controls VCR tape or DVD disc functions: Stop,
Rewind, Play/Pause, Fast Forward.
∑ RESET button
If your remote control is not functioning properly, take
out the batteries and press the reset button for about
2~3 seconds. Re-insert the batteries and try using the
remote control again.
13
Remote Control Buttons
ΠPOWER button
Turns the PDP on and off.
´ ASPECT button
Press to change the screen size.
ˇ Number buttons
¨ +100 button
Press to select channels over 100. For example, to select
channel 121, press “+100”, then press “2” and “1.”
ˆ MUTE button
Press to mute the PDP sound.
Ø VOL (Volume) buttons
Use it to adjust volume.
∏ SLEEP button
Press to select a preset time interval for automatic shutoff.
” MENU button
Displays the main on-screen menu.
’ ENTER button
Confirms a selection.
˝ PIP button
Activates picture in picture.
Ô STILL button
Press to pause the current screen.
 LCD Display
When you press a button, ‘ ‘ appears along with
selected mode (TV, VCR, CATV, DVD or STB) and
remaining batteries on LCD.
Ò P.MODE button
Adjust the PDP picture by selecting one of the preset
factory settings (or select your personal, customized
picture settings.)
Ú MODE button
Selects a target device to be controlled by the Samsung
remote control (ie., VCR, Cable, DVD players or STB).
If you change modes, the new mode is momentarily
displayed on LCD.
Æ PRE-CH button
Tunes to the previous channel.
ı TV/VIDEO button
Press to display all of the available video sources
(ie., Video, S-Video, Component1, Component2, PC, DVI).
˜ CH (Channel) buttons
Use it to switch channels.
¯ INFO button
Press to display information on the PDP screen.
˘ EXIT button
Press to exit the menu.
¿ Up/Down Left/Right buttons
Control the cursor in the menu. 12
Remote Control
Installing the Batteries in Your Remote Control
1 Slide the back cover
to open the battery
compartment of the
remote control.
3 Slide the cover back into
place.
2 Install two AAA size batter-
ies. Make sure to match the
“+” and “-” ends of the bat-
teries with the diagram
inside the compartment.
Remote Control Operation Range.
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
from the left and right sides of the PDP’s remote control receiver.