Samsung MX-HS7000-ZA - Manual (Page 21)

03
Functions
3. Select a station by:
• Pressing and holding the TUNING/
ALBUM , or . button on the remote
control to automatically search for active
broadcasting stations.
4. Press the MO/ST button to switch between
stereo and mono.
• In a poor reception area, select MONO
for a clear, interference-free broadcast.
• This applies only when listening to an
FM station.
5. If you do not want to store the radio station
found, go back to Step 3 and search for
another station.
Otherwise:
a. Press the ¬ button.
b. Or, press the TUNING/ALBUM button
on the remote control to select a
program number in the PRESET mode.
c. Press the ¬ button to save the preset.
6. To store any other radio frequencies
required, repeat Steps 3 to 5.
|NOTES |
✎ In Tuner mode
- In the Manual mode, you can use the 1
or 2 button or the DJ JOG control.
- In the Preset mode, you can use the 1
or 2 button or the DJ JOG control on
the product to search for a stored radio
station.
Selecting a Stored Station
To listen to a stored station, follow these steps:
1. Select FM by pressing the TUNER/AUX
button on the product or remote control.
2. Press the TUNING MODE button on the
remote control until “PRESET” is displayed.
3. Press 1, 2 button on the main unit or
TUNING/ALBUM ,, . on the remote
control to select a preset number.
or
Turn the DJ JOG control left or right on
the main unit to select the stored station.
Timer Function
Setting the Clock
For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
1. Press the TIMER SET button on the remote
control twice. "CLOCK " is displayed.
2. Press the ¬ button on the remote
control. The hour flashes.
• T
o increase the hours: TUNING/ALBUM ,
• To decrease the hours: TUNING/ALBUM .
3. When the correct hour is displayed, press
the ¬ button, and then the minutes
flash.
• To increase the minutes: TUNING/
ALBUM ,
• To decrease the minutes: TUNING/
ALBUM .
4. When the correct minute is displayed,
press the ¬ button, and then " TIME"
appears in the display.
Setting the Timer
The timer enables you to set the product to
switch on or off at specific times automatically.
• Before setting the timer, check that the
current time is correct.
• For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
• If you no longer want the product to be
switched on or off automatically, you must
cancel the timer by pressing the TIMER
ON/OFF button.
Example: You want to wake up to
music every morning.
1. Press the TIMER SET button until TIME
is displayed.
2. Press the ¬ button.
Result: ON is displayed for a few seconds.
You can set the timer switch-on time.
21
English
02680D-MX-HS6000-ZA-ENG-20140304.indd 21 2014/3/17 15:47:46