Samsung EC-HZ25WZBPBUS - Manual (Page 54)

053
Auto Focus type
You can select your preferred Focus Area according to the shooting
conditions.
[Center AF] ( ) : The rectangular area in the
center of the LCD monitor
will be focused
[Multi AF] ( ) : This camera selects all of
available AF point from the 9
AF points.
[Selection AF] ( ) : Focus on the desired position of the LCD monitor.
[Tracking AF] ( ) : The focus moves along with the movements of a
subject.
Ä When the camera focuses on the subject, the auto focus frame
turns to green. When the camera doesn't focus on the subject, the
auto focus frame turns to red.
Functions ( )
Ŷ How to Enable Selection AF
After setting [Selection AF], press the OK
button and then the screen for setting the
location of a focus frame will appear.
Press the Up/Down/Left/Right button to
move the focus mark to the desired position.
Press the shutter button to enable Selection
AF. Once setting is complete, the focus mark
will be ¿ xed at the position set.
Press the OK button once again to change the location of the focus
frame and the focus frame will appear again.
Ä Even if you turn off the power and turn on it again, the previous set-
ting will be maintained.
Ä [Selection AF] is not available when operating the [Face Detection]
function.
Focus Mark
Flash Intensity
You can control À ash intensity. (You can set À ash intensity within the
range of +/- 2EV in intervals of 1EV.)
[-2], [-1], [0], [+1], [+2]
Ɣ The [Flash EVC] function is not available in the [Smart Auto],
[Beauty Shot], [Scene] and [Movie], [Night] modes.
Ɣ If the subject is too close or the sensitivity is too high, changing
the value to a negative value (-) may not have any effect.
Ɣ If the À ash intensity is out of the control range because the
exposure value is too high or low, the camera may not operate
properly.
Focus Area
Back Move
-2 -1 0 +1 +2
Flash EVC
Back Move