Samsung KN55S9CAFXZA - Manual (Page 169)

162
Anynet+ (HDMI-CEC)
There is something
wrong with the TV.
Try this!
Anynet+ does not
work.
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
Only one external device may be connected to
Receiver
.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
Navigate to the
System
menu and verify that
Anynet+ (HDMI-CEC)
is set to
On
.
Check whether the TV remote panel is in TV mode.
Check whether the remote panel is Anynet+ compatible.
Anynet+ may not function under certain circumstances. (Searching channels,
operating Smart Hub or
Setup
, etc.)
If you have disconnected and then reconnected the HDMI cable, scan for devices
again or turn your TV off and on.
I want to start
Anynet+.
Check if the Anynet+ device is properly connected to the TV and then navigate to
the
System
menu to see if
Anynet+ (HDMI-CEC)
is set to
On
.
After checking, select the virtual remote panel's
TOOLS
button to display the list.
Select Anynet+ (HDMI-CEC) from the list.
I want to exit Anynet+.
Select
View TV
from the Anynet+ menu.
Select a non-Anynet+ device from Source .
The message
"Connecting to
Anynet+ device..."
or "Disconnecting
from Anynet+ device"
appears on the screen.
You cannot use the remote panel when you are configuring Anynet+ or switching
to a viewing mode. Use the remote panel after the TV has completed the Anynet+
configuration or has switched to a viewing mode.
The Anynet+ device
won't play.
You cannot use the play function when
Setup
is progress.
The connected device
is not displayed.
Check whether the device supports Anynet+.
Check whether the HDMI cable is properly connected.
Navigate to the
System
menu and verify that
Anynet+ (HDMI-CEC)
is set to
On
.
Scan for Anynet+ devices again.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
The TV audio is not
being played through
the receiver.
Connect an optical cable to the TV and the receiver.
ARC enables digital sound to be output via the HDMI (ARC) port.
However, ARC is only available when the TV is connected to an audio receiver that
supports ARC.