Alpine PXA-H701 - Manual (Page 35)

34
-EN
Installation and Connections
3
Mount the spacer and bracket to the control unit.
Next, securely mount the factory brackets
removed from the factory radio, to the control
unit assembly.
Flush Mounting the control unit
1
Make a cut-out approximately 178 (width) by 50
(height) mm (7 inches by 2 inches) in size at your
desired mounting location.
WARNING
When making cut-outs, be careful not to
damage pipes, tanks, electric wires, etc. Doing
so could lead to accidents or fire.
2
After step 2 on “Mounting other units” of
“Mounting the control unit” page 33, remove the
side bracket.
3
Remove the spacer from the bracket.
Side bracket
Side bracket
Spacer
Bracket
Control unit
Spacer
Pan head screw
(M3 x 5) x 2
4
Mount the spacer on the control unit using the
included screws.
5
Attach the flush mount brackets to the control
unit using the included screws. Mount this
assembly into the prepared cut-out.
Flush mount
Face plate
Self-tapping screw
(M2.6 x 8) x 4
Flat head screws (M5 x 8)
Bracket