Alpine PXA-H701 - Manual (Page 6)

5
-EN
EN
FR
ES
DE
SE
IT
Adjusting the input level
Using the analog, RCA-type connections, the
PXA-H701’s input level must be preset from the
head unit.
Adjust the input level using a sound source with
a high recording level (such as pop or rock
music).
1
Turn on the head unit’s power.
2
Turn the Rotary encoder on the main unit
counterclockwise and set the volume level to “0”.
3
Gradually increase the volume of the head unit
until “INPUT LEVEL OVER” appears in the
display.
Reduce the volume slightly from this position,
until “INPUT LEVEL OVER” display just turns off.
This completes the setting.
Do not change the head unit volume level from
this optimum setting. Use the PXA-H701, only,
for changing the volume level.
NOTE
Switch to the spectrum analyzer display mode or the
input channel display mode before adjusting the input
level. (See page 29)
Adjusting the volume, balance, fader and subwoofer
After determining the input level, adjust the
volume, balance, fader and subwoofer from the
PXA-H701. Be careful not to make these
adjustments on the head unit.
1
Press the ENTER button and select the mode to
be adjusted.
2
Turn the Rotary encoder within 5 seconds and
adjust to the desired level.
VOLUME : 0 ~ 35
BALANCE : L15 ~ R15
FADER : F15 ~ R15
Sub.W LEVEL : 0 ~ +15
NOTE
When the subwoofer is set to “OFF”, the Sub.W
LEVEL adjustment is ineffective.
Using with RCA-type or optical cable
connections (non Ai-NET connections)
(only when using the control unit sold
separately)
Switching the input
The PXA-H701 is equipped with three sets of
analog signal inputs and three sets of digital
signal inputs. For further information about
connections, see Page 36.
1
Press the SETUP button.
The setup mode is set.
2
Turn the Rotary encoder to select the “INPUT
SELECT” mode, then press the ENTER button.
3
Turn the Rotary encoder to select the input
mode, then press the ENTER button.
4
Press the SETUP button repeatedly to quit the
setup mode.
NOTE
Non Ai-NET connections
Alpine products are equipped for a bus connection
system called “Ai-NET” which can only be used for
connections between Ai-NET products.
The PXA-H701 is an Ai-NET product, but is designed to
allow connections to other (non Ai-NET) products as
well. Thus RCA-type and optical cable connections are
also possible.
Connections to non Ai-NET products are referred to as
“non Ai-NET connections”.
Analog 1 Analog 2 Analog 3
Digital 3 Digital 2 Digital 1
VOLUME FADER BALANCE
Sub.W LEVEL
Using with Ai-NET connections
When Ai-NET connections are used, the volume,
subwoofer, balance and fader are adjusted from
the head unit (they cannot be adjusted from the
PXA-H701). However, BASS and TREB can not
be adjusted from the head unit, so adjust them
from PXA-H701.