Samsung LS22CRNSF-XAA - Manual (Page 23)

the monitor using the AV or S-Video cable.
2. Connect the port of the DVD, VCR (DVD / DTV Set-Top Box) to the [L- AUDIO-R] port of the monitor.
Then, start the DVD, VCR or Camcorders with a DVD disc or tape inserted.
Select AV or S-Video using the '
'.
2. Connecting TV - Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like the diagram to the right, see
"Antennas with 300 Ω Flat Twin Leads" below.
If your antenna has one lead that looks like the diagram to the right, see
"Antennas with 75Ω Round Leads".
If you have two antennas, see "Separate VHF and UHF Antennas".
1. Antennas with 300Ω Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300Ω twin flat
leads, follow the directions below.
1-1. Place the wires from the twin leads under the screws on a 300-75Ω
adapter (not supplied).
Use a screwdriver to tighten the screws.
1-2. Plug the adaptor into the ANT 2 IN (CABLE) terminal on the back
of the TV.
2. Antennas with 75Ω Round Leads
2-1. Plug the antenna lead into the ANT 1 IN (AIR) terminal on the
back of the TV.
3. Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine the
two antenna signals before connecting the antennas to the TV. This procedure requires an
optional combiner-adaptor (available at most electronics shops).
3-1. Connect both antenna leads to the combiner.
3-2. Plug the combiner into the ANT 1 IN (AIR) terminal on the