Samsung LS22CRNSF-XAA - Manual (Page 43)

Menu Description Play/Stop
Antenna You can select a normal or wired channel.
If the antenna is connected to ANT 1 IN (AIR),select "Air" and if it is connected
to ANT 2 IN(CABLE), select "Cable". If both ANT 1 IN (AIR) and ANT 2 IN
(CABLE) are connected, select the antenna input you want. If the antenna input
is not selected properly, noise may appear on the screen.
The direct button on the remote control is 'ANTENNA' button.
Air
Cable
- MENU → ▼ → ＋ → ＋ → ▼ →
Auto
Program The TV automatically cycles through all of the available channels and stores
them in memory.
In rare cases, "Auto program" may miss a few channels due to weak signals
and the channels may not be added to the channel memory.
Air
Cable
Air+Cable
- MENU → ▼ → ＋ → ▼ → ＋ → ▼▼ → ＋ →
Clear
Scrambled
Channel The Clear Scrambled Channel function is used to filter out scrambled
channels after "Auto Program" is completed. It removes the scrambled
channels from the list by tuning the digital cable channels.
This process may take up to 20~30 minutes.
- Available in Digital Cable TV Mode Only
- MENU → ▼ → ＋ → ▼ → ＋ → ▼▼ → ＋ → → MENU
Channel
List You can manage the channels.
The direct button on the remote control is 'CH LIST' button.
- MENU → ▼ → ＋ → ▼ → ＋ → ▼▼ → ＋ → → MENU
Fine Tune Due to weak signals or an incorrect antenna configuration, some of the
channels may not be tuned correctly.
- Available in Analog TV Mode Only
- MENU → ▼ → ＋ → ▼ → ＋ → －＋ → → ▼ →
LNA Amplifies signals when antenna reception is poor. However, if incoming signals
are interfering with each other, turn off LNA as it may malfunction.
Off / On
- MENU → ▼ → ＋ → ▼ → ＋ → ▼▼ →
Signal
Strength Unlike analog channels, which can vary in reception quality from "snowy" to
clear, digital (HDTV) channels have either perfect reception quality or you will
not receive them at all. So, unlike analog channels, you cannot fine tune a
digital channel. You can, however, adjust your antenna to improve the reception
of available digital channels.
If the signal strength meter indicates that the signal is weak, physically adjust
your antenna to increase the signal strength. Continue to adjust the antenna
until you find the best position with the strongest signal.
- Available in DTV Mode Only
- MENU → ▼ → ＋ → ▼ → ＋ →
Setup