Samsung RF23HSESBSR-AA - Manual (Page 21)

5. The sparkling water concentration is set to ‘2’ by default.
Press the “Sparkling Water” button to set the concentration to a desired level, and then press and hold the Quick
Sparkling button for 3 seconds to activate the Fill Up function.
If the Sparkling Water function is deactivated, press and hold the Sparkling Water or Quick Sparkling button for 3
seconds to reactivate it.
Once the CO
2
cylinder is reset, sparkling water is produced.
• To produce sparkling water, the sparkling water tank is filled with water and CO
2
gas is injected according to the
selected concentration.
• To remove foreign substances that may exist in the sparkling water tank, discard the first quart of sparkling water.
• The refrigerator will not dispense sparkling water while it is making sparkling water.
When the numbers ( ) next to the sparkling water icon stop blinking, you can dispense sparkling water.
Press 3 seconds
OR
Press 3 seconds
• To uninstall a SodaStream Carbonator, follow steps #1 ~ #4 above in reverse order.
For more information about using the Sparkling Water function, see Using the Sparkling Water Function.
Completing the Set Up
Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational.
1. Make sure your refrigerator is in an appropriate location with reasonable clearance between it and
the wall. Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour.
The freezer will get slightly chilled and the motor will run smoothly.
Reset the refrigerator and freezer to the temperatures you want.
4. After you plug in the refrigerator, it takes a few hours to reach the appropriate temperature.
You can store food and drinks in the refrigerator after the temperature is sufficiently cool.
If condensation or water drops appears on both sides of fridge door’s central part, turn the
Energy Saver mode off after removing the condensation. (See the explanation of the Energy
Saver button in USING THE CONTROL PANEL on page 23.)
English - 21
SETTING
UP