Samsung RF23HSESBSR-AA - Manual (Page 32)

CAUTION
Note that the ice cubes in the ice bucket may
spill out over the drawer when you remove the ice
bucket from the drawer.
If this occurs, be sure to pick up the ice cubes
that spilled out of the drawer.
CAUTION
If a power failure occurs, ice cubes may melt, and
then freeze together when the power comes back
on, causing the dispenser to stop working.
To prevent this problem, after a power failure, pull
out the ice bucket as shown above, and then
discard the residual ice or water.
If you use all the ice in the bucket at once,
you must repeat ice making Steps 2 and 3
on the previous page.
However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes.
This will replenish the ice cubes and
ensure maximum ice production.
Using the ice off Function
When you select the Ice Off mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it difficult to
remove them.
To remove the ice bucket safely and avoid injury,
hold the bottom of the bucket with one hand and
the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight
out.
To put the ice bucket back in, push it firmly
straight back.
If the ice bucket is not pushed firmly into
place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and
try again.
CAUTION
• The inside of the ice bucket is very cold when
the refrigerator is operating.
Do not reach deep inside the ice bucket.
• Use only the ice maker provided with
the refrigerator. The water supply to this
refrigerator must only be installed/connected
by a suitably qualified person.
Connect to a potable water supply only.
• To operate the ice maker properly, water
pressure of 20 ~ 125 psi is required.
English - 32