Samsung HG28NC673AFXZA - Manual (Page 7)

7
English
Connecting a Pillow Speaker (NC673 Models only)
You can connect a pillow speaker to the TV in the hospital using a jumper cable. The speaker functions as a remote control
and speaker. (Jumper cable not provide)
Pillow Speaker
HDMI
IN 3
HDMI
IN 3
PILLOW
OUT
Jumper Cable
TV Rear Panel
1. Connect the pillow speaker jumper cable (cable sold separately) from the television's PILLOW SPEAKER Port to the pillow
speaker jack on the wall behind the television.
Pillow Speaker Jack Specifications
y Output jack: RCA type
y Input jumper pin: 1/8" 3-conductor stereo phone pin.
y Signal specifications: Tip-Audio, Ring-Data/Channel change, Sleeve-Common
TIP Ring Sleeve
How to Use the Pillow Speaker
y Analog type speaker: The pillow speaker has one key.
– Power On: press the key when the TV is in standby mode.
– Channel Up: press the key when the speaker is on.
– Power Off: press and hold the key for more than 3 seconds when the speaker is on.
– An Analog type speaker always works regardless of the Pillow Speaker Type value set in the Hospital mode setup
menu.
y Digital type speaker: The TV supports the Samsung, Philips, or Zenith code.
– This speaker is only compatible with a specified IR code. You can change the code in the Hospital mode setup menu.
– The TV gives priority to the Samsung remote control over the pillow speaker's wired remote control.
– Option : Channel Menu Display.
Pillow Sound Control
Speaker Selection Menu TV Speaker Pillow Speaker
TV Speaker Sound Sound
External Speaker No Sound Sound
[HG673-ZA]Install Guide-X0ENG.indd 7 2014-03-07 10:20:16