Alpha Technologies FLEXNET POWER MPS48-7M - Manual (Page 14)

14 021-511-B4-002, Rev. B
4.0 Installation
4.1 Unpacking the MPS48-7M
Remove the mounting bracket and enclosure from the
shipping carton. Inspect the MPS48-7M for shipping
damage.
Verify each carton contains:
• MPS48-7M enclosure
• Mounting bracket and hardware
• 3/4" 3-hole strain relief fi tting
• 1/2" strain relief fi tting
• Cable ties
• Quick Start Guide
4.2 Enclosure Installation, Wall-mount or Wooden Pole-mount
Most codes require the base of the enclosure to be located a minimum height from the
ground. Always verify height restrictions before installation.
Before installing an enclosure, the location and method of mounting must be approved by the property owner.
ATTENTION:
Recommended Tools and Materials:
• Ratchet with 7/16" socket
• Level
• Phillips
screwdriver
• Two user-supplied 1/4" x 2-1/2" (7mm x 60mm) lag bolts with fl at washers
• Stud fi nder (optional)
Installation Procedure:
1. Remove the mounting hardware from the inside of the bracket
and position the bracket on a wall or wooden pole capable of
supporting 35 lb. (16kg). Use a backing plate if necessary.
2. Level the bracket vertically with the tab facing up.
3. Secure the bracket to the wall or pole using two user-supplied
1/4" x 2-1/2" lag bolts. The hardware must sit fl ush inside the
bracket dimples for proper installation.
Lag Bolt
Lag Bolt
Tab