Alpha Technologies FLEXNET POWER MPS48-7M - Manual (Page 16)

16 021-511-B4-002, Rev. B
4.0 Installation, continued
4.3 Enclosure Installation, Steel or Concrete Pole
To mount the MPS48-7M on concrete or steel poles, two user-supplied mounting straps
are required (straps must be stainless, galvanized, or equivalent). Most codes require the
base of the enclosure to be located a minimum height from the ground. Always verify height
restrictions before installation.
Before installing an enclosure, the location and method of mounting must be approved by the property owner.
ATTENTION:
3. Secure the enclosure to the bracket using the four self-
tapping screws with washers (supplied).
Required Tools and Materials:
• #2 Phillips screwdriver
• Two user-supplied pole straps to fi t pole (straps must be
stainless, galvanized or equivalent)
Installation Procedure:
1. Position the bracket at the appropriate height with the tab
facing up. Secure it to the pole using the pole straps.
2. Hang the enclosure on the bracket.
Tab