Asus Motherboard DSBV-D - Manual (Page 92)

4-24 Chapter 4: BIOS setup
4.4.2 Chipset Configuration
This menu shows the chipset configuration settings. Select an item then press
<Enter> to display a pop-up menu with the configuration options.
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit →← Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Select ECC error
conditions that
SERR# be asserted.
Chipset Configuration
Crystal Beach Configure Enable [Enabled]
SERR Signal Condition [None]
Demand Scrub Enable [Enabled]
Patrol Scrub Enable [Enabled]
4GB PCI Hole Granularity [256 MB]
Memory Branch Mode [Interleave]
Branch 0 Rank Interleave [4:1]
Branch 0 Rank Sparing [Disabled]
Enhanced x8 Detection [Enabled]
Force ITK Config Clocking [Disabled]
FBDIMM(s) Thermal Throttling [Open Loop]
Open Loop Type [Best Performan]
Environment Temperature [025 ºC]
PhoenixBIOS Setup Utility
Advanced
Crystal Beach Configure Enable [Enabled]
Allows you to enable or disable the Configuration/Memory mapped accesses to the
Crystal Beach Configuration space located in Device 8, Fn 0, and Fn 1.
Configuration options: [Disabled] [Enabled]
SERR Signal Condition [None]
Allows you to select the ECC error that the SERR# asserts.
Configuration options: [None] [Single Bit] [Multiple Bit] [Both]
Demand Scrub Enable [Enabled]
Enables or disables the Demand Scrubbing.
Configuration options: [Disabled] [Enabled]
Patrol Scrub Enable [Enabled]
Enables or disables the Patrol Scrubbing.
Configuration options: [Disabled] [Enabled]
4GB PCI Hole Granularity [256 MB]
Allows you to select the granularity of the PCI hole for PCI resource.
Configuration options: [256 MB] [512 MB] [1.0 GB] [2.0 GB]
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit →← Select Menu Enter Select Sub-Menu F10 Save and Exit
Temperature Rise [025 ºC]
FBDIMM(s) Air Flow [2.0]
Scroll down to display the following item: