Sierra Monitor Company FS-8700-48 - Manual (Page 12)

FS-8700-48 Fike Cheetah Manual Page 13 of 37
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
5.3.2 Driver Specific Map Descriptor Parameters
Column Title Function Legal Values
Cheet_Zone*
A Map Descriptor may be used to store data for one, all or no
zones. To store data from multiple zones, multiple Map
Descriptors must be declared, each specifying the zone of
interest. When specifying “All”, the data for zone 0 is stored in
the first element of the Data Array defined by the
Data_Array_Name & Data_Array_Offset and the data for zone
127 in the 128th element of the Data Array.
Depending on the firmware version of the Cheetah panel some or
all of the following states are available. Abort, Trouble,
Supervisory, Zone Disable, Pre-Alarm, Alarm, Pre-Discharge,
Release, Process.
To store data for multiple states, multiple Map Descriptors must
be declared - One per state of interest.
None, All, 0-127
Must be None when
Cheet_Device is not equal
to None.
Cheet_Device*
Define one or more Map Descriptors to store data from the 0-127
addressable devices. Each Map Descriptor must have the
Cheet_Zone set to None.
Devices belong to one of 4 possible loops. Thus when
Cheet_Device is set to All or to a specific device number, the
Cheet_Loop number must be set to a value from 1 to 4.
If Cheet_Device is set to All then 128 states are stored. The data
for device 0 is stored in the first element of the Data Array
defined by the Data_Array_Name & Data_Array_Offset and the
data for device 127 in the 128th element of the Data Array.
None, All, 0-127
Must be None when
Cheet_Zone is not equal
to None.
Cheet_Loop
Specify this parameter when the value of Cheet_Device is not
equal to none.
None, 1-3
Must be None when
Cheet_Zone is not equal
to None.
Cheet_DT*
Data Type. Multiple Map Descriptors are required to store
multiple states in one/more Data Arrays.
Abort, Trouble,
Supervisory, Disable, Pre-
Alarm, Alarm, Pre-Dis,
Release, Process, Any, All,
History, Panel
Only Alarm and Trouble
are valid when storing
device data
Length
The length of the Data_Array that will be used to store the
information. Ensure that the length is sufficient to store all
information (e.g. for Zone Data the minimum length is 241
(Enough space for Zones 0-240).
1-10,000
Cheet_Func* Use for active Map Descriptors only Port Response, -