Sierra Monitor Company FS-8700-48 - Manual (Page 25)

FS-8700-48 Fike Cheetah Manual Page 26 of 37
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Appendix C. Troubleshooting
Appendix C.1. Driver Error Messages
Multiple protocol drivers may exist on a FieldServer. Each driver may produce its own error messages and the
FieldServer itself may produce error messages.
All messages produced by this driver begin "Cheetah:"
Error Message Action Required
Cheetah:#1 Unknown
simulation function.
Report these messages to FieldServer Technologies.
Cheetah:#2 Simulation
function unknown.
Cheetah:#3 Protocol Error
(Start),
Incoming msg
ignored - Waiting for next
msg.
Warning messages only. An incoming message was discarded because the
identifiers which mark the beginning of a message could not be found. You
cannot take any action to correct this message. If it occurs often check wiring,
noise and installation. Cheetah:#4 Protocol Error
(Stop),
Incoming msg
ignored - Waiting for next
msg.
Cheetah:#5 Protocol Error
(Chksum), Incoming msg
ignored - Waiting for next
msg.
Cheetah:#6 Protocol Error
(Unknown), Incoming msg
ignored - Waiting for next
msg.
Report this error to FieldServer Technologies.
Cheetah:#7a Err. Zone=%d
Max=%d
Cheetah:#7b
MapDesc
Error. Zone value error.
(%d)
Cheetah:#7c FYI. Warning.
Zone=%d. Max zone is panel
type
dependent. Read
Manual.
An invalid zone has been specified. The zone causing the problem is printed in
parenthesis.
4
The largest possible zone number is 255. Only Cybercat panels support this
number of zones. Legacy panels support up to zone 239. Very old panels that
can only send message #6 can only report information for 127 panels.
If you are connected to a Cybercat panel and you get the FYI message you can
ignore it. If you are connected to some other panel and you get either the Err or
FYI message then you will need to correct the CSV file.
Cheetah:#8 MapDesc Error.
Device value error. (%d) An invalid device has been specified. The device causing the problem is printed
in parenthesis.
4
Cheetah:#9 MapDesc Error.
Loop value error. (%d) An invalid loop has been specified. The loop causing the problem is printed in
parenthesis.
44
4 Modify the CSV file, download to the FieldServer and restart the FieldServer for the changes to take effect.