Alpine cda-9825 - Manual (Page 21)

19
-EN
3
The CD Changer Selection mode remains active for 8
seconds after step 2 is performed. Press the BAND/
TEL. button until the desired CD Changer indicator
appears on the display.
NOTE
If the selected CD Changer is not connected, the display will
show “NO CHGR .”
Alternatively press the BAND button on the Remote
Control until the desired changer indicator appears on
the display.
4
To operate the selected changer, see “CD Player
Operation” section.
NOTE
For further details about the external input (AUX) when using
KCA-410C, see ”Setting the AUX Mode (V-Link)" on page 12.
2
Press the Disc Select buttons (1 through 6)
corresponding to one of the discs loaded in the CD
Changer. The selected disc number appears in the
display and CD playback starts.
NOTES
• After selecting the desired disc, you can operate in the same
way as for the CDA-9827/CDA-9826/CDA-9825 CD player.
For details, please see the CD Operation section.
• If the underlined portion of the “FUNC” indicator is
illuminated, the Disc Select buttons become nonfunctional.
When a 12-disc CD Changer is connected:
To select discs numbered from 1 to 6, the procedure is
the same as for the 6-disc CD Changer. To select discs
numbered from 7 to 12, first press the “F” button. This
changes the “D” indicator to “d.” Then press the desired
Preset button. With the “F” button activated, the Preset
buttons 1 to 6 will represent discs 7 to 12 respectively.
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Changers. When operating two or more changers, the
KCA-400C (Multi-Changer Switching device) must be
used. If you use 1 Switching device, you can connect up
to 4 CD Changers. If you use 2 Switching devices, you
can connect up to 6 CD Changers. When using KCA-
410C (Versatile Link Terminal), you can connect two
changers and two external outputs (AUX).
1
Press the SOURCE/POWER button on the CDA-9827/
CDA-9826/CDA-9825 to activate the CD Changer
mode.
Alternatively, press the SOURCE button on the Remote
Control (CDA-9827 only) to activate the CD Changer
mode.
2
Press the BAND button on the CDA-9827/CDA-9826/
CDA-9825 or the RUE-4187 to activate the CD
Changer Selection mode.
BAND SOURCE