AEG L 98485 FL - Manual (Page 23)

STARTING A PROGRAMME
1. Touch button 6 to start the pro-
gramme. The indicator of button 6
stops to flash and is on with red col-
our.
If a delayed start is set, the appliance
starts the countdown.
The appliance adjust automat-
ically the cycle time to the
laundry you have put in the
drum to have perfect washing
results in the minimum neces-
sary time. After approximately
15 minutes from the start of
the programme, the display
shows the new time value.
INTERRUPT A PROGRAMME
1. Touch button 6 . The indicator
flashes.
2. Touch button 6 again. The washing
programme continues.
CANCEL A PROGRAMME
1. Press button 1 to cancel the pro-
gramme and to deactivate the appli-
ance.
2. Press button 1 again to activate the
appliance. Now, you can set a new
washing programme.
The appliance does not drain the
water.
CHANGE A FUNCTION
You can change only some functions be-
fore they operate.
1. Touch button 6 . The indicator
flashes.
2. Change the function set.
3. Touch button 6 again. The washing
programme continues.
OPEN THE DOOR
While a programme or the delay start op-
erates, the appliance door is locked.
To open the appliance door:
1. Touch button 6 . The door lock
symbol in the display goes off and a
message tells you that the door is un-
locked.
2. Open the appliance door.
3. Close the appliance door and touch
button
6 again. The programme or
the delay start continues.
If the temperature and the level of
the water is too high, the door
lock symbol stays on. You cannot
open the door. If necessary, do
the following procedure to open
the door:
1. Deactivate the appliance.
2. Wait for some minutes.
3. Make sure that no water is in
the drum.
If you deactivate the appliance, it
is necessary to set the programme
again.
AT THE END OF PROGRAMME
1. The appliance stops automatically.
2. The acoustic signals operate, if it is
active.
3. In the display goes on and the
message tells you that the pro-
gramme is completed.
4. The indicator of button 6 goes off.
5. The door lock symbol goes off.
6. Press button 1 to deactivate the ap-
pliance. After five minutes from the
end of the programme, the AUTO
OFF function automatically deacti-
vates the appliance.
When you activate the appliance
again, the display shows the end
of the last set programme. Turn
the programme knob to set a new
cycle.
ENGLISH
23