Specifications, Heating specifications, Dimensions – Avalon Stoves Arbor PS User Manual

Page 6: Electrical specifications, Fuel, Epa compliance

Advertising
background image

6

Specifications

© Travis Industries

4070806

1 0 0 - 0 1 1 9 1 _ 0 0 0

Heating Specifications

Approximate Maximum Heating Capacity (in square feet)* ........................................800 to 2,250 Sq. Feet
Burn Rate (Pounds per Hour)**............................................................................1.7 to 5.5
Maximum Burn Time on Low Burn** ......................................................................29 Hours
Hopper Capacity ..............................................................................................50 Pounds

*

Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is also affected
by the fuel size, quality, and moisture level.

**

Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% depending on fuel
quality may occur.

Dimensions

Center Line

7-3/4"

NOTE:

Measure front and side clearances from the

stove top. Rear and corner clearances are

measured from the stove body.

Weight: 390 Lbs.

27"

27-1/4"

25"

27-3/4"

17-1/4"

4" Diameter

Exhaust

Electrical Specifications

Electrical Rating.........................................................................................115 Volts, 3.6 Amps, 60 Hz
Watts During Start-Up Sequence ...................................................................400 (approximately)
Watts During Operation ...............................................................................180 (approximately)

Fuel

• This heater is designed and approved for pelletized wood fuel or a mixture up to 50% corn, 50% pellets.

See page 26 for details on using a corn pellet mix.

EPA Compliance

This heater has been tested exempt from EPA Phase II Requirements by OMNI-Test Laboratories, Inc.

Advertising