Configuring snmpv1 and v2c – Allied Telesis AT-TQ Series User Manual
Page 143
AT-TQ Wireless Access Point Series User’s Guide
143
Configuring SNMPv1 and v2c
You may use SNMPv1 and v2c to manage the access point and receive
traps from the unit. Here are the guidelines to managing the device with
SNMP:
You can use SNMP to manage only a subset of the features of the
device. You have to use the web browser interface to manage all
the features.
The access point does not support SNMPv3.
The access point can have only one read-only community string
and one read-write string.
The MIB for the product is available from the Allied Telesis web
site.
The unit must have an IP address for SNMP management. For
instructions, refer to “Assigning a Static IP Address to the Access
Point” on page 36 or “Assigning a Dynamic IP Address from a
DHCP Server to the Access Point” on page 38.
To enable or disable SNMP, perform the following procedure:
1. Select SNMP Settings from the Services menu.
The access point displays the “SNMP Configuration” window, shown in
Figure 45 on page 144.