Allied Telesis AT-TQ Series - Manual (Page 22)

Chapter 1: Overview
22
Starting a Management Session on the Access Point
This section explains how to start a management session on the access
point from your management workstation. The procedure assumes that
the access point has already been assigned an IP address. The address
can be a static address that was manually assigned to the unit or it can be
a dynamic address from a DHCP server.
Note
If the access point has not been assigned an IP address and is
using its default address 192.168.1.230, refer to “Starting the Initial
Management Session on the Access Point” on page 23 for
instructions on how to start a management session.
To start a management session on the access point, perform the following
procedure:
1. Open the web browser on your management workstation.
2. Enter the IP address of the access point in the URL field of the web
browser.
You should now see the logon window, shown in Figure 2.
Figure 2. Log On Window
3. Enter the username and password for the unit. The default values are
“manager” for the username and “friend” for the password. The
username and password are case-sensitive.
4. Click the Logon button.