Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 267)

Spanning-Tree Commands
Page 266
User Guidelines
The path cost method is configured using the spanning-tree pathcost method Global Configuration mode
command.
Example
The following example configures the spanning-tree cost on Ethernet port 1/e15 to 35000.
spanning-tree port-priority
The spanning-tree port-priority Interface Configuration mode command configures port priority. Use the no form
of this command to return to the default configuration.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
Parameters
•
priority — The priority of the port. (Range: 0 - 240 in multiples of 16)
Default Configuration
The default port priority for IEEE Spanning TreeProtocol (STP) is 128.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the spanning priority on Ethernet port 1/e15 to 96.
spanning-tree portfast
The spanning-tree portfast Interface Configuration mode command enables PortFast mode. In PortFast mode,
the interface is immediately put into the forwarding state upon linkup without waiting for the standard forward time
delay. Use the no form of this command to disable PortFast mode.
Syntax
spanning-tree portfast
no spanning-tree portfast
console(config)# interface ethernet 1/e15
console(config-if)# spanning-tree cost 35000
console(config)# interface ethernet 1/e15
console(config-if)# spanning-tree port-priority 96