Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 334)

AlliedView™-EMS 4.0.2 Device Management Guide Page 334 of 441
IP
Address Table
Standard
Displays the list of IP interfaces on the switch.
Note - The Re-assemble Max Size parameter is not applicable to the AT-
x900-12X series and should be ignored.
Additional
Info
Displays the information of the IP Address of the device.
Note - Device Manager does not handle objects of type OCTET STRING
correctly. As a result, the Address parameter will display a sequence of bytes
in hexadecimal format instead of the actual IP address of the device.
Note - The current firmware version does not allow the Port Number and
Assignment Type parameters to be configured.
Note - The current firmware version allows the user to enter up to 128
characters for the Label parameter but truncates entered values to 127
characters.
Note - Configuring Prefix Length parameter will result in the error message
"The error occurred with 'Set' operation. Error: time out occurred."
However, the new value is still set successfully.
Route Number
Displays the IP routing number on the switch.
Route Table
Displays the IP routing table on the switch.
Note - The current firmware version returns the value 'NULL' for the Routing
Protocol MIB parameter.
Note - The following parameters are implemented as 'read-only':
•
Destination Port Number
•
Routing Type
•
Routing Protocol MIB
•
Next Hop AS Number
•
Destination Metric 1
•
Destination Metric 2
•
Destination Metric 3
•
Destination Metric 4
•
Destination Metric 5
•
Row Status