Allied Telesis AT-S63 - Manual (Page 37)

AT-S63 Management Software Features Guide
37
Management Interfaces
The AT-S63 Management Software has four management interfaces:
ˆ Standard command line
ˆ AlliedWare Plus command line
ˆ Menus
ˆ Web browser windows
As shown in Table 10, the standard command line and the web browser
windows are supported on all of the possible platforms: stand-alone
AT-9400 Layer 2+ Switches, stand-alone AT-9400 Basic Layer 3
Switches, and AT-9400 Stacks. The AlliedWare Plus command line is not
supported on the AT-9400 Layer 2+ Switches and the menus interface is
not supported on AT-9400 Stacks.
You can access the standard command line, the AlliedWare Plus
command line and the menus from local management sessions and from
remote Telnet and Secure Shell clients. The web browser windows are
available from remote web browsers using either non-secure HTTP or
secure HTTPS.
The standard command line is the only management interface that lets you
configure all of the parameters on stand-alone switches and stacks. The
other management interfaces support only a subset of the management
functions. For instance, you can use any of the management interfaces to
configure the basic settings of the ports (e.g., speeds and duplex modes),
but you have to use the standard command line to configure VRRP.
Table 10. Management Interfaces
Standard
Command
Line
AlliedWare
Plus
Command
Line
Menus
Web
Browser
Windows
AT-9400
Layer 2+
Switches Y Y Y
AT-9400
Basic Layer
3 Switches Y Y Y Y
AT-9400
Stacks Y Y Y