Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 266)

AlliedView™-EMS 3.11 Device Management Guide Page 266 of 402
General Info
Displays general information about the switch.
Note - The current firmware version does not return the correct value for the
Hardware Version parameter of the following models:
• AT-9408LC/SP
• AT-9424T/GB
• AT-9424T/SP
• AT-9424Ts
Note - L2+ Models: The current firmware version returns an incorrect value for the
RPS Present parameter. If the device is connected to an RPS, the RPS Present
parameter returns 'disconnected'. If it is not, it returns 'connected'.
Uplink Info
Displays uplink information.
Temperature Info
Displays temperature information.
Note - This table applies to L2+ models only.
Fan Info
Displays fan information.
Note - This table applies to L2+ models only.
Voltage Info
Displays voltage information.
Note - This table applies to L2+ models only.
Management Info
General Config
Displays management configuration information about the switch.
Note - AT-9408LC/SP: The current firmware version does not allow the
Configuration Action parameter to be configured.
Note - The current firmware version returns "???(0)" for the Action parameter.
Access Lists
Displays management access lists for the switch.
Note - Device Manager does not handle objects of type BITS correctly. As a result,
the Application parameter may display any of the following values: