Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 376)

AlliedView™-EMS 3.11 Device Management Guide Page 376 of 402
Note - AT-RG600 ADSL: Attempting to configure the parameters under the
Additional Info sub-menu option for LAN 4 will not result in an error but the new
values will not be applied.
Note - AT-RG634A: Valid MIB Set values for the Receive Limit and Transmit Limit
parameters are in the range [0-1000000] inclusive. However, the current firmware
version allows these parameters to be set to more than the maximum value.
Note - AT-RG656BD : When a LAN or WAN port is configured to auto-negotiate
and is connected to a 100Mbps full or half duplex port on another device, the
current firmware version returns '10000000' for the Speed parameter under the
Standard sub-menu option. As a result, the speed displayed on the RJ-45 LAN port
images is '10' instead of '100'.
Note - AT-RG656BD: The current firmware version returns '???(195)' for the Port
Type parameter of the 100Base-FX WAN port.
Note - AT-RG656BD : By default, the WAN port is enabled. However, once
disabled, it can no longer be enabled until the device is reset to factory defaults.
Note - AT-RG613xx: Attempting to configure any of the parameters under the
Additional Info sub-menu option while a telnet connection is open will not result in
an error message, but the new values will not be applied.
Voice
Displays information for each voice port.
Note - If the user has no read access to the Admin Info MIB group, the association of
the end-point to the voice port may be incorrect for the following context menu
options:
• Dial Info
• Call Forwarding Info
• CLI Info
• Quality Info
• Statistics
As a result, when a user right clicks on a voice port (e.g. TEL1) and chooses any of
these context menu options, the information that will be shown may be for TEL 2
instead.
Note - AT-RG634A: The value displayed for the Port parameter is '???(0)'.
Note - AT-RG634A: It may take a while to retrieve information from the device. As
a result, the value 'no such instance' may be displayed by default. Once the retrieval
process is complete, the actual values for the different MIB variables will be shown.
This applies to the following sub-menu options: